Seven Pickleball Dinking Drills Build Slice, Roll, Short Hop, Reach

  • A seven-pattern dinking session from Richard Pickleball and his hitting partner Zack trains the slice, roll, reach, short hop and bump, per The Dink.
  • Each pattern pairs two dink types and runs about five minutes, so a full pass on one side takes about 35 minutes with a partner or a ball machine.
  • The habits that decide progress are short balls, recovery after every shot, a tip-down paddle on rolls, a reach for deep balls and a one-second hold on sitting balls.

Seven Dinking Patterns Build A Dink For Every Situation

Most players get good at one dink, and opponents pick them apart at the kitchen line. A routine of “dink back and forth until someone misses,” leaves a lot of improvement on the table.

The fix is variety. A complete kitchen player owns a slice, a roll, a reach, a short hop and a bump, and switches between them without thinking about it. This session trains all five. Richard Pickleball, who posts on YouTube, built it with his hitting partner Zack across countless reps. It runs with a partner or with a ball machine, and its seven patterns stress every dink you will face in a real match.

Plan on about five minutes for each pattern. Seven minutes works if you have the energy, but expect to tire, as you bend for every single ball. Run the full set from your backhand side, repeat it from the other side of the court, and you have a block of 35 to 70 minutes that covers nearly every dink situation.

Each Drill Pairs Two Dink Types

Every drill puts two different dinks against each other. One player works a shot while the other forces that player to adapt. The design mirrors a match, where opponents keep changing the spin, depth and direction of the ball they send, and it applies the same pressure you meet against a patient opponent.

The lineup:

  • Slice to slice, the baseline dink
  • Roll to slice
  • Roll to short hop
  • Slice to roll, the switched version
  • Short hop to roll
  • Roll to roll
  • Forehand middle patterns, with a short hop and a roll to the middle

Run the list on your backhand side first, then from the other side. With five minutes per drill, one side takes about 35 minutes. At five minutes a drill, one side takes about 35 minutes.

Drill 1: Slice To Slice Sets The Baseline

Slice to slice is the foundation. Both players slice dink and grind the exchange short in the kitchen. If your slice is shaky, perfect the backhand slice dink before you add the other patterns.

Richard focuses on three habits here.

First, keep every ball short. If your partner hits one a little deep, take it out of the air with a slice.

Second, cross step when the ball goes wide. In a game you often get stuck and have to move fast, so practice the footwork on purpose.

Third, recover after every hit. Do not reach and stay there. That is not what you do in a point, and the drill should simulate real match movement.

Drills 2 And 3: Roll To Slice And Roll To Short Hop

In roll to slice, one player rolls while the other answers with a slice, using a reach when the roll comes deep. Richard prefers pushing the ball over slicing it out of the air. He drops the paddle and pushes through short balls, and he reaches for the deep ones.

Your roll will meet many answers. Opponents can short hop it, back up, or take it early, and you need a response for each.

Roll to short hop is the next step. The roller sends the ball a little deeper, and the other player short hops everything. The key is how wide your ball travels. A short hop that drifts wide gets attacked. Get your paddle around the ball and keep it short in the kitchen. The roller should move the ball around, including some right at your feet. You want to handle every location, not just the easy ones.

What A Short Hop Dink Is

A short hop dink is a dink you hit right after the ball bounces, usually when the ball lands deeper in the court and you cannot hit it out of the air. You move forward or slide back, meet the ball just after the bounce, and guide it softly into the kitchen, the seven-foot non-volley zone on both sides of the net.

The shot is defensive and controlling at the same time. Master it and deep dinks stop being a threat. They become one more ball you can handle.

Drills 4 And 5: Switch The Roles

Once you finish the first set, flip the roles so both players train both sides of each pattern. Richard now rolls while Zack slices, then Richard short hops while Zack rolls. Drill 4 is slice to roll, the switched version, and drill 5 is short hop to roll.

Watch the paddle tip on every roll. Get the tip down and cup the ball. That tip-down position gives you the most control on a roll dink.

Deep balls will show up, and they are part of the work. A ball that goes long is still part of the drill, so take it, work with it and reset the rally.

Drill 6: Roll To Roll Is The Hardest Pattern

Roll to roll is the toughest pattern. Both players roll, and that demands real footwork and quick decisions. If it overwhelms you, skip it for now and come back as your control improves.

The rule is simple. If your partner sends a ball too deep, do not roll it. Reach and bump it instead. Rolling a ball that is too far back ruins the drill, and in a match it hands your opponent a chance to attack. Be ready to reach first, then roll once you can tell the ball is not too deep. Balls on the line still get rolled, as long as they are not way behind the kitchen.

Both players keep getting the tip down and wrapping around the ball. That habit also fixes dinks that pop up.

The One-Second Hold And Drill 7: Forehand Dinks From The Middle

When your partner hits a dead or sitting ball, hold your paddle up for one second before you drop it and swing. Nothing changes in your motion. You delay the start, wait, then drop and go. Opponents react to your timing instead of the ball, and many will jump, move or make an error. The hold is one of the best ways to add deception without adding complexity.

The last pattern targets forehand dinks from the middle, a shot many players neglect while they grind on the backhand. One player short hops to the middle while the other works a forehand dink and controls it. Richard uses the same hold here: prep up, drop the paddle, then go.

His footwork stays simple. He does not step out with his right foot first. He drops the paddle and moves through the ball. To finish the session, alternate the short hops between wide and middle while the other player rolls everything. Then run the full list from the right side of the court too.

The Session Checklist And The Ball Machine

Across all seven patterns, six habits decide whether you improve:

  • Keep the ball short in the kitchen, not wide and not deep.
  • Recover after every shot as if you were in a real point.
  • Get the paddle tip down on rolls for control.
  • Reach for deep balls instead of forcing a roll.
  • Use the one-second hold on sitting balls.
  • Do not cheat by leaning or reaching and staying put.

Consistency beats power here. Run both sides of the court. The patterns are the same, but your body mechanics and footwork change, and training both sides keeps a weak side from forming that opponents can target.

No partner? Run most of the session solo with a ball machine. Set it to feed short or deep dinks at different locations, and work the patterns where you are the one hitting: short hops, rolls and reaches. The machine cannot recover or change spin on its own, so you lose a little realism. It still stacks reps when you cannot find a partner. Pair it with live drilling when you can.

Why Dink Variety Wins Points

Opponents change spin, depth and direction constantly, so relying on one dink makes you predictable. Richard exploits exactly that. He is comfortable slicing, short hopping and reaching, while many opponents can only do one dink well. A player with a great slice should also own a great roll, a clean bump and a reliable short hop. Missing any one of them caps how far you can climb.

The best players treat dinking as a toolbox and not a single shot. A dink is a setup shot, and the kitchen strategy principles behind it say to keep dinking until an opponent hits a ball high enough to attack. Every pattern in this session builds a way to stay in that exchange under a different kind of pressure.

The session also fits inside a larger routine. Eric Roddy’s two-hour practice plan gives the first ten minutes of its drilling hour to dinking and then moves to speed ups with a reset defense. This session gives dinking a much longer block of its own.

Build The Toolbox On Both Sides

Treat the seven patterns as a checklist of dinks you must own. Start with slice to slice, add the rolls and short hops, save roll to roll for when your footwork can keep pace, and finish with the forehand from the middle. Hold the paddle up for a second on every sitting ball, get the tip down on every roll, and reach before you roll a deep one. Then repeat the whole list from the other side of the court so no weak side is left for an opponent to find.

George Howson

About George Howson

George Howson is a contributor to Racket Chronicle and an AIPS accredited journalist. An engineer and writer, he is known for asking direct questions and reporting plainly.

Leave a Comment